Double RJ45 Telephone and Data Socket is built to the standard (85mm x 85mm) electrical faceplate size, and can be attached to an industry standard electrical box (BS4662) concealed in wall for flush-mounted or to an ABS back box for surface-mounted installation. Two 8-position RJ45 jack are housed in each socket unit. Each 4 pairs of Category 5e UTP cable are terminated at the RJ45 jack with pin assignment according to TIA/EIA-568-B standard (designation T568A). The left side 4 pairs are terminated to the left side jack, and the right side 4 pairs are terminated to the right side jack only.
Specification
Transmission Performance
- Compliance with EIA/TIA-568-B.2 Category 5e performance (characterized up to 100 MHz)
Socket Faceplate
- ABS UL94V-0.
- 85 x 85 x 8 mm
Faceplate Back Cover
- PC transparent back cover
RJ45 Jack
- Two RJ45 jacks, each with 8 contacts, gold plating over nickel plating in contacts area
- All contacts protected in guide slots
- Able to mate with RJ45 & RJ11 plugs without jamming
- The 8-position jack contacts are not damaged or deformed after repeated insertions and withdrawals of an RJ11 plug
Insulation Displacement Contact (IDC) Terminal
- Four IDC with total 16 positions to terminate up two 4-Pairs UTP cables.
- Marked with identification numbers and colors
- Able to terminate at least 2 wires of the same conductor gauge (0.4 mm to 0.63 mm) at each position
IDC Cover
- PC transparent cover
Shutter
- Full shutter for each jack
- ABS UL94V-0
- Spring loaded
- Upward to flap open
- Free from jamming when the plug is inserted or withdrawn
Line Test Circuit
- Reserved space on printed circuit board for horizontal mounting a test circuit of diode-resistor across each line
- Diode Type 1N4004 (400 V, 0.5 W)
- Resistor value 470 kΩ±5%, 0.5 W
Printed Circuit Board
- Double-sided Plated Through Hole (PTH) FR4 material |